We install, repair and maintain walk-in cold rooms for butchers, caterers, bakeries, food producers and shops. That covers panel and door work, condensing units, evaporators, defrost controls, temperature monitoring and the drainage that quietly decides whether the floor stays dry.
Existing rooms get a condition assessment first: panel integrity, door seals, insulation, plant capacity and control calibration, with a clear list of what must be fixed now and what can wait. Where a room was built into a space that cannot ventilate the condensing unit, that is the first thing we address, because no amount of gas will fix a plant that cannot reject heat.
What the work covers
- New cold room design, panels and installation
- Condensing unit, evaporator and defrost repair or replacement
- Cold room doors, seals, heaters and closers
- Temperature control calibration and monitoring
- Panel, floor and drainage repair
- Scheduled defrost, coil clean and performance checks
Symptoms we are usually called for
- The room struggles to hold temperature during a busy morning
- Heavy ice on the evaporator or ceiling
- A door that no longer seals or closes on its own
- Water or ice on the cold room floor
- Temperature swings overnight that put stock at risk
Cold rooms by suburb
We deliver cold room installation & repairs for butcheries, catering kitchens, food producers, shops and delis across Grassy Park, Lansdowne, Ottery, Lotus River, Pelican Park and Strandfontein. Each suburb has its own access, dust and damp conditions, so the pages below describe how this service actually runs there.
Questions about cold rooms
Can an old cold room be upgraded instead of replaced?+
Often yes. New plant and controls on sound panels can restore performance at a fraction of a rebuild. We test panel integrity and door seals first, because fitting new plant behind leaking panels wastes money.
How long does a cold room installation take?+
A small single-compartment room is usually a day or two of assembly and commissioning once the panels and plant are on site, plus the electrical connection. Access, floor condition and the route the panels have to travel decide most of the schedule, which is why we survey before quoting.
Why does my cold room ice up?+
Almost always defrost: a failed heater, a termination sensor that reads wrong, a blocked drain, or a controller set for a room that is now used differently. Ice blocks airflow, and a room that cannot move air cannot hold temperature.