We install, repair and maintain air-cooled and water-cooled chillers and the associated pumps, controls and pipework for light industrial and commercial sites around Ottery, Lansdowne and Grassy Park. Duties range from a small process cooler to a packaged chiller serving a production line.
Chiller work is measurement-heavy: approach temperatures, refrigerant pressures, water flow, glycol concentration, condenser condition and control setpoints. Guessing at a chiller is expensive, because the difference between a fouled condenser and a failing compressor shows up in the same place, a rising leaving-water temperature.
What the work covers
- Air-cooled and water-cooled chiller installation
- Compressor, condenser and evaporator repairs
- Pump, flow switch and control fault finding
- Glycol concentration and freeze protection checks
- Condenser cleaning and heat exchanger maintenance
- Planned maintenance with written condition reports
Symptoms we are usually called for
- Leaving water temperature creeping up under load
- Frequent high-pressure or low-pressure trips
- The chiller short-cycling or refusing to start
- Ice forming on the evaporator or pipework
- Flow alarms and pumps that sound rough
Chillers by suburb
We deliver chiller installation & maintenance for light industrial units, food production, commercial buildings, process cooling across Grassy Park, Lansdowne, Ottery, Lotus River, Pelican Park and Strandfontein. Each suburb has its own access, dust and damp conditions, so the pages below describe how this service actually runs there.
Questions about chillers
How often should a chiller be serviced?+
For a production site, quarterly is a sensible baseline, with condenser cleaning more often where the environment is dusty. A chiller that runs continuously without attention loses efficiency quietly and then fails at the worst moment.
Can you work on three-phase plant?+
Yes. Chiller and cold room plant is usually three-phase, and we check supply, protection and isolators as part of the survey rather than assuming the board can carry the new load.
What does planned chiller maintenance include?+
Condenser and evaporator condition, refrigerant pressures and temperatures, current draw, water flow and quality, glycol strength, control setpoints, safety devices and a written note of what is wearing and what it will cost to address.