Ice on the evaporator means defrost
A freezer evaporator has to be warmed periodically to melt the frost it collects. If the heaters, termination sensor or controller timing are wrong, that frost stays and grows. Common causes are a failed heater, a sensor reading the wrong temperature, a defrost cycle set too short for the room's door traffic, or a drain that refreezes before it clears.
Ice at the door frame means air is getting in
Warm, moist air enters through a poor seal or a failed door heater, and freezes on the coldest surface it finds. A door that no longer closes on its own, a torn gasket or a heater circuit that has died will all produce the same pattern. Left alone, the door eventually freezes shut and staff start forcing it.
Ice on the ceiling or floor means the envelope
Ceiling ice can point to a failed panel joint or a roof leak above the room. Floor ice often means a drain problem or ground water under an insulated floor. Neither is fixed by adjusting the plant, which is why an honest assessment has to look at the room as a building, not just at the refrigeration unit.
In short
- Evaporator ice is a defrost fault, not a gas fault.
- Door-frame ice is a seal or heater fault.
- Ceiling and floor ice point at panels, roof or drainage.